- To enter the [Ring Inside] mode, press [Finger Mode] button.
- Set the sharp tool into the rotary chuck as shown below.
- Press
button to switch to [Move mode-Rotary].
- When the LCD window displays the following (as shown below), press
button to change the [Z-axis mode].
- Use buttons to horizontally align the tip of the engraving tool to the tip of the blade (as shown below). Use buttons to adjust the distance between tools. Be sure the tips are closer to each other.
- Press the
button to display save confirmation on the LCD window.
- Short press button: Temporary save (message guide X)
- Long-press and hold button (for more than 3 seconds): Permanent save
- Press the
button to save the setting.