- Measure the width and diameter of the ring.
 |
 |
| Outer marking – Ring outside size | Inner marking – Ring inside size |
- Insert the ring into the chuck finger (as shown below) then tighten the rotation clamp to firmly secure the ring.
 |
 |
| Ring outer engraving | Ring inner engraving |
[Object position]
[Engraving direction]
The direction of the characters to be engraved on the ring is shown in the picture below. Check the target location (where you want your characters to be engraved on the ring) then firmly secure the ring.
- Double-click “Ring” template in the object property window. When [Insert Rotary Object Template] window appears, select one marking option: outside or inside. Then enter the width and diameter of the ring and click “OK.”
- The template will appear at the center of the screen. Select
[Text Input] on the toolbar then click at any target area on the work area to enter the text to mark.
- After entering the text, click
[Selection] on the toolbar to enter the object selection mode. Select the text, then edit its size and font. To place the text at the center of the work area, click 
[Center in Page] button.
What is Handle for adjusting gaps between characters?
Handle for adjusting gaps between characters is a function that adjusts gaps between characters by dragging characters to target positions.
- Upon completing the design, click
[Hatching Toolpath] button.
✽Click
button on the top right of the screen for immediate marking without creating a Toolpath.
- The “Hatching Toolpath” window will appear (as shown in the picture below). Select the tool, toolpath gap and depth then click “Create Toolpath” button.
- The “Toolpath” object is created with red lines marked or filled on each text (as shown in the picture below). Scroll up the mouse wheel to zoom in the image of the toolpath object to check the line style. You may delete the toolpath object and create a new one if the toolpath is not your preferred style.
9. After selecting your preferred toolpath, click button.
- Once “NC Output” window appears, specify how the engraving material is measured then click “Start Engraving” button.
| Surface height | Measure material height. |
| Multi point measurement | Measure material height by dividing the whole material into several parts (up to 5 times) |
| Outside | Engrave on the ring’s ring outer diameter. |
| Inside | Engrave on the ring’s ring inner diameter. |
 |
Place the material on the flat chuck finger. |
 |
Place the material on the round chuck finger |
11. Once the tool is positioned to the center of the material and the laser pointer turns on, use the direction key buttons to position the laser pointer to the engraving area. The area that the laser pointer points to is where the actual engraving takes place.
 |
Press the direction key buttons to move the laser pointer to the left, top, right and bottom areas of the engraving area. (Long press to move the laser pointer farther). Check if the laser pointer points to the area on the material where you want to engrave. If the laser pointer is out of range, adjust the position using the direction keys. The laser pointer automatically points to the area where the engraving takes place (based on the target location on the work area). When the direction key is pressed, the laser pointer moves to the area to be engraved (left, top, right or bottom) from its target location. If the engraving area needs to be adjusted to the left, press |
key to move the pointer to the left.
- After positioning the laser pointer and determining the location of the engraving area, long-press and hold
button (for more than 3 seconds) until it beeps to confirm that the machine is ready to engrave then close the cover.