To enter Menu mode, press 
button. Select a menu item using the 
and 
buttons then press 
button to enter the menu item.
| 1. Tool Change | Changes the tool. | |
| 2. Select Origin | Sets the current position to the clamp origin. | |
| 3. Calibration | 1. Touch Sensor | Adjusts touch sensor settings. |
| 2. Probe | Adjusts probe settings. | |
| 4. Measure Z-Ref | 1. Height Only 2. Horizontal(X) Slope 3. Vertical(Y) Slope 4. Plane(XY) Slope *In rotary mode, only [1. Height Only] is enabled. |
|
| 5. Adjust Brightness | 1. Status LED | Adjusts status LED brightness |
| 2. Inside LED | Adjusts inside LED brightness | |
| 3. Pointer | Adjusts focus laser pointer brightness | |
| 6. Vacuum Setup | Sets the Chip collector function. -Set to automatic control. -Set the Chip collector type: Dry/wet type |
|
| 7. Tool-Pos Recording | Records your current location; set whether to activate or not. | |
| 8. Auto Zref on Repeat | Sets Auto Zref method for repetitive engraving: 1. No measurement 2. Height measurement 3. Height measurement + area check |
|