 |
Direction Key (X,Y) |
Engraving area adjustment  (X) Moves X axis  (Y) Moves Y axis |
|
 |
Laser pointer | Pointer On/Off | Laser pointer On/Off |
| Pointer Calibration | Set laser pointer calibration | ||
 |
Origin | Origin change (Short press button) |
Current tool location • Another location: Move to the origin • Origin: Move to the another origin (Center ↔ Left-top origin) |
| Origin save (Press and hold button for more than 5 seconds) |
Save the current position as the origin. | ||
 |
Start | Start marking button • Start marking: Long-press (for 2 seconds) the [Start] button to start marking. • Repeat marking: Press the [Start] button to finish marking, then double-press (tap twice) the [Start] button to repeat marking. • Menu: Press OK when using the menu. |
|
 |
Auto focus | Auto focus (Short press button) |
Activates camera auto focus position • Auto moves to view position after height measurement • Refreshes the camera display at MagicEngrave. ※Variety of features available for use once MagicEngrave software is enabled. |
| Touch sensor -Tool Calibration- (Press and hold button for more than 5 seconds) |
Adjusts touch sensor settings | ||
 |
Stop | Stops/cancels marking | |