MAGIC™-L3 cannot operate alone as a desktop engraver. It cannot proceed to laser marking and cutting operation without the use of a computer and a software.
The machine should be connected to a personal computer for the machine to operate. The software provided along with the machine must be installed to the computer to run the program for laser marking and cutting.
¶ How to install the machine
- To start the machine, plug its power cable into a grounded outlet. ※See precautions for use for safety.
- To connect the machine to the computer, plug in the USB cable on the back of the machine then on the computer’s USB port.
¶ Power switch
¶ Emergency Switch
※If the machine won’t turn on, check the emergency switch.
