¶ Package Contents
MAGIC™-L3 provides the following tools and devices. The contents of the package may vary if optional items are purchased.
Take note:
*Make sure to replace laser source regularly or as per maintenance schedule.
*All pictures shown are for illustration purpose only. Images may differ from the actual products.
*Be sure to use a safety mask and safety glasses to avoid injury during machine operation.
|
Name |
Picture |
Qty |
Usage |
|
MAGIC™-L3 |
 |
1EA |
Laser marking machine |
|
Power adapter (CP-02) |
 |
1EA |
Power supply ※Use a grounded outlet only. Do not plug the machine into an ungrounded outlet. |
|
USB Cable (CP-11) |
 |
1EA |
For connecting to PC |
|
Program Installation USB |
 |
1EA |
To install MagicEngrave software ※See program installation for further details. |
|
User Manual |
 |
1EA |
Operating manual |
|
Clamp (LMB-21) |
 |
1SET |
Support for material positioning. |
|
Clamp Bolt (M5-12mm) (LMB-21B) |
 |
4EA | To fasten the clamp. |
|
L-wrench (4mm) (CP-L40) |
 |
1EA |
For tightening/replacement of bolt. |
|
L-wrench(3mm) (CP-L30) |
|
1EA |
For setting the focus pointer. |
|
L-wrench (2mm) (CP-L20) |
|
1EA | For setting the focus pointer. |
|
Ruler (CP-24) |
 |
1EA |
For measuring the material. |
|
Clamp Pin (6Ø)(LMC-11) |
 |
2EA | To secure the medal clamp. |
¶ Optional
*Purchased separately
|
Name |
Picture |
Qty |
Usage |
|
Power Cable (Right angled) |
 |
1EA |
Power supply |
|
USB Extension Cable (Left angled) (LMC-36) |
 |
1EA |
For connecting to PC |
|
Back cover (LMC-253) |
 |
1EA |
For protecting the port from scratches. ※Use the power cable (Right angled) and USB cable (Left angled). |
|
Medal Clamp (LMB-102) |
 |
1SET |
For holding materials with various shapes in place. |
|
Medal Clamp (Center fixing type) (LMC-020) |
 |
1SET |
For holding materials with various shapes in place. |
|
L type clamp (LMB-101) |
 |
1EA |
For holding materials with various shapes in place. |
|
Auto tilt Rotary Clamp (LMC-161) |
 |
1SET |
For holding ring materials in place. ※4mm chuck finger is included. |
|
Auto-tilting bangle clamp |
 |
1EA |
Bangle material fixing clamp |
|
Honeycomb Table (LMC-071) |
 |
1SET |
For holding materials in place during cutting process. |
|
Anti-Curling Clamp (LMC-031) |
 |
1EA |
For holding a thin plate in place. |
|
Blower Box (LMC-200) |
 |
1SET |
Exhaust for dust & smoke. ※ Using a dust collector or blower rated over 2A may cause machine malfunction. Do not connect or use products that exceed 2A. |
|
Auxiliary Power Device (LMC-101) |
 |
1SET |
Auxiliary Power Device must be used if the external blowers or dust collectorshave more than 2 Ampere. |
※All pictures shown are for illustration purposes only. Images may differ from the actual products.