| Bakelite plate (120x100x2t) |
 |
- Camera can be calibrated in the MagicEngrave program.
- Use the
button to adjust the red line (that appears on the screen) to center of the clamp. Once the red line is adjusted to the center, click [Next].
- Place and secure the bakelite to the clamp. Set the calibration area to 90 x 70mm then click [Create Line]. Check the calibration results then click [OK].
- Press and hold the
button (for more than 3 seconds) until it beeps to start engraving. A rectangle will be engraved for calibration.
- Align the red corner marks to the calibration line corners with the mouse or keyboard.
- Check the calibration results on the program. Be sure that the red lines are marked over the calibration lines. Click [OK] to complete the calibration.
